The caliper eventually arrived and did not fit my 2020 model. It’s not billet ergal as stated on their website, it’s a cast aluminium that has been cnc machined to shape.
If you hand a 2014-2016 it would fit if you had a 320mm disc.
The problem is the mounting bracket which places the caliper...
Hi,
I have ordered a Discacciati front calliper. Couldn’t find any info or reviews from anyone about it so I took a punt and bought one.
Cnc billet ergal. 4x34mm pistons.
I will report back once I get it and fit it up.
I’m running a complete Aracer setup. RC super 2 ecu, WB01 wideband and 2 way quickshifter. Works well, bike runs great even though I have only used the auto tune feature to set it up so far. Had a few minor glitches to start with but the more I ride the better it gets. I recommend it but it...
I used the original brake lines. I haven’t removed the abs. Just loosen all of the brake line clamps and pinch as much slack as your u can without pulling them too tight.
Would anyone have the bearing size or bearing number for the output shaft bearing RH side - #7 on the diagram? I have the part number, i need the actual number off the bearing or its dimensions. Currently not In stock in australia so i need to go to the bearing shop and get one before...
Not sure if this has been covered before, however, for anyone who is struggling to remove their header pipe from the engine because it is fouling between the frame and the engine the solution I found was to remove the top coolant hose from the engine and pull it free. I had already removed the...
Hi Ltyson, I have fitted a brembo rcs15 corsa corta to mine with clip ons.
I found that I had to install steering stops (I used the ktm power parts stops) and relieve the fairing stay by grinding away a small section to allow clearance for the lever adjuster. I also trimmed the fairing (front...
I have a set of ti retainers from gray area KTM (waiting to be fitted). I only emailed Paxton the other day about this and his retainers are machined to provide increased seat pressure.
Hope that helps.
Hi radwan, I am talking to a friend who does Carbon parts and the power parts heal guards are one of the things I want him to do. I’m thinking of modifying the right side heal guard slightly for a better fit around the brake master cylinder.
I will keep you posted if you’re happy to wait a few...
If you look on the wiseco website they have information about single ring pistons and discuss how Honda achieved this with their CRF through specific ring design.
Hi Kostean and Superpacman, I’m in for that. Happy to do standard bore too. I guess there must be reasons why the big bore development didn’t go anywhere.
Bigger bore is something I would like to do as well. I’m not sure if the barrel has enough meat to do it, but it is feasible to bore and re-plate an aluminium cylinder.
If someone has any knowledge about cylinder bore thickness I would be interested to know. Again, in Australia, we have several...