Apologies if this is the wrong place to ask.
I was doing an oil change earlier. When I removed the bottom fairing a set of something (washers?) fell off from it and I don't know where they should go. I was able to put the bottom fairing back without these things but I'm slightly...
Hey everyone!
So, I just installed my R6 shock a couple days ago. I have a question about the bushing kit. When I ordered it, it said I needed a kit for the top and the bottom bolt. But, when I installed the shock, I only needed the bushing for the bottom bolt. Did anyone else run into...
Hello all, On the left side fairing the carbon filter is attached with a rubber clip. I have looked everywhere I can online and can not find how to route the drain hose with the plug and metal clip on the bottom of it. Currently I have it going down the fairing through the metal holder that the...
KTM will not sell the individual fork assembly pieces you have to buy the hole fork.
Below are the parts sheets for both bikes.
They both have the same part number for the assembled forks, but the axel holder\foot\stanchion, whatever you want to call it, the black piece the screws onto the...
The piston has three rings and a circular wire (looks a bit like a spring).
Anyone know where the wire gets installed?
I'm thinking it goes in the gap of the bottom ring, but it doesn't want to stay there, so I'm wondering if it goes somewhere else?
Thanks,
Mike
Thought everyone might like these links to the PDFs with the exploded parts diagrams. I have a 2015 so I posted these specific links. The link at the bottom will help navigate to other PDFs.
http://ktmamerica.com/part_books/2015/street/2015%20RC%20390%20WHITE%20CHASSIS%20PARTS%20MANUAL.pdf...
Recently purchased a GPR Ghost exhaust from chrisdigital here on the forum. Quite happy with it and I'm running the bottom db killer based on personal preference. However, Chris trimmed the elbow off it and I would prefer to have the full elbow to direct gas outwards if possible.
If anyone...
Me and my RC390 made the weeks best photo's on US 129 Photos, scroll down on home page bottom left second one up. Just past the bear!
http://www.129photos.com/
This is just a public service announcement for folks who are running the Tyga rearsets... CHECK YOUR REAR BRAKE LEVER STOP ADJUSTER.
I've just gotten my 3rd report from someone who's had the adjuster fall off, which then allows the brake lever to swing WAY too far up... So, look at the bottom...
I searched, honest. I even tried to look it up in the CD service manual, but was unable to get that bahstid to work (see thread to this effect). Here's what was going on, and hopefully someone can post up the correct spec for the next person who searches:
I have mounted the T-Rex Racing frame...
I have a track day later this week and was going to ride my bike as is (stock). Wondering if anyone is putting a catch can at the end of the coolant hose (the one that dumps out the bottom of the bike). As most know the belly pan isn't sealed so I want to prevent any coolant from getting on the...
The RC Cup racers were instructed by the AMA guys to drill a hole in the bottom of the airbox. Apparently the airboxes were fillng up with water in the rain event. Drill a hole at the bottom of the airbox on the LHS. The hole will allow water to drain out avoiding the engine 'drowning'. The CUP...
First i searched the forum for suitable panniers & mounting system for my RC390. I came up blank so I bodged a support system for mounting a set of GIVI Silver soft panniers I had laying about the garage. I don't have welding skills, although I eventually would like to re-fabricate the...