signal

So I bought A fender eliminator kit and installed it on the 390. After installation only the left turn signal would work because the right wire had been sandwich behind the mount. I freed the wire but now I have NO lights anywhere on the bike, and the engine won’t start. Display turns on no...

My turn signal swithc broke after 24,000 miles and 3 years. That's not a very long time for part to last. From what I can see, KTM doesnt sell the switch itself separate from the entire cluster. Do I have to spend $40 now because of this asshole little part? Does anyone know a way to get a hand...

I would like to attach a tachometer to the RC390 model of the 2015 model, but what kind of color wire should be connected on which side to receive the engine rotation signal? Also, where is the wire?

So my turn signal decided to pop out of its rubber stalk. I've tried pushing and rotating the turn signal back onto the rubber stalk but it doesn't seem to be working. Is there a way I can get this thing back on properly? I'd rather not use electrical tape or glue. Thanks in advance.

Hello. Because the tachometer and the shift indicator of the genuine meter were small and the visibility was bad, I wanted to install the shift light LIGHTRONIC LT 200, but in order to install it I have to pick up the engine rotation signal. Is there a person who knows where to get the engine...

Shipping to 95819. Let me know what you got!

I am trying to install a gear indicator with shift light which is much bigger and easier to see than the stock dash. I have removed ABS so I do not have the front speed sensor anymore, however, I did keep the rear speed sensor since Bazzaz needs it. The rear speed sensor has 2 wires, and it...

I have two issues. Will PC5 with WBC2 handle them both, please? I am technical by nature, but I have *no* experience of Dynojet products and it's a lot of money to spend on an experiment. Any experiences, please? This is a road bike, my daily ride to work :-) 1) Excessively rich and stalling...

Anybody know if it is possible to connect the speed input of the PCV to the rear wheel sensor? If so what wire is used for the signal? I tried both wires going to the sensor.

. As most of you know everywhere else in the world, the RC390 comes with Nice LED Turn signals on the Mirrors. So we wanted to do something similar.......... But better. Many of you probably see more and more cars are going the way of AUDI's and coming with LED Daylight Running lights...

. Parts arrived. Should have some time this weekend to do VIDEO Install and Review. Sexy Stainless steel plate with Stainless hardware , and a Bright LED Tag Light. Too keep the cost down, the kit utilizes your stock signals.............But, we will be offering Short Stalk Signal Upgrade, if...

When i was wheeling my KTM into the garage I noticed that my left rear turn signal was dangling by the wires. KTM mounted the turn signals on flexible stalks to prevent breakage in case of a minor get off. I must have hit the turn signal hard enough with my boot when I was dismounting to...

Is anyone having problems with the instrument panel? I noticed that my clock was NOT accurate (running through about 2 hours every 15 minutes), and now it has actually stopped: at 4:44. This is not catastrophic, just an annoyance, but I will have to call the dealer on Tuesday and talk to them...