silverstarnc
New Member
Does anyone know how to remove the factory bar ends? I've taken the bolts out but how do you remove the insides?
guzz46
New Member
I don't know if you can, if you're planing on using bar end mirrors, just use the thread already there.
Treachery
Moderator
I haven't looked at it yet. Roll back the grip and see if there's a retaining tab that you press. If you don't have any luck, PM me and I'll see what I can discover from the service CD.
gbabyracing
Member
The bars are solid and threaded on the ends. You've removed the bolt - give the bar end a good bump and it'll pop off.
Treachery
Moderator
Ah-so there's a solid plug, not just an insert. Thx!
Treachery
Moderator
Does that go for the clutch side as well, gbaby? The throttle side came off, but the clutch side won't budge.
Rexbo
Member
They're both the same. Get the fastener out and knock 'em off, the glue will give some resistance.
Treachery
Moderator
I took a rubber mallet and was able to remove it. Serious overglue. See other (upcoming) thread.
Similar threads
