High beam not working

Lukeh

New Member
Country flag
Hello, I was wondering if someone could help me. I recently installed a tail tidy kit on my bike and now my high beam switch does not work, my low beam and high beam flash is working so I don’t think it’s the bulb I have noticed I wire coming out of a connector from under the seat when I was installing the tail tidy I’m not sure if this is the issue because someone else on the forum said they had the same wire hanging out. I have attached the picture of the wire hanging out the picture is from the forum. The only thing that is different is my wire is purple
 

Attachments

  • E60CEA8F-EEBD-4447-844F-23CEAE851B83.jpeg
    E60CEA8F-EEBD-4447-844F-23CEAE851B83.jpeg
    391.2 KB · Views: 12

matadorCE

Member
Country flag
I remember seeing that same wire hanging out. Start with checking the basics like fuses, etc. and then move to the wiring with a voltmeter. I had an issue when I installed my tail tidy where the license plate light wouldn't illuminate but that was due to a poor connection. I didn't think you could affect the main or high beam by tapping into the turn signals for the tail tidy.
 
Top