Biker
Member
Found a 3d file on thingiverse for a quick throttle cam for a YZF R6 RJ03 by mastein93 (https://www.thingiverse.com/mastein93) and printed it off in ABS.
https://www.thingiverse.com/thing:2800913
It fits the RC 390 perfectly except needing just a little bit of fettling on the bottom half of the housing. Glued it in place using superglue. Pics in links below which should be self explanatory.
Pics and a small vid:
https://photos.app.goo.gl/LH8Kx2qVwDu2giZA8
Areas which I had to fettle on the throttle housing lower half:
https://photos.app.goo.gl/Un6gEo2poQ12C3GK9
WOT points:
https://photos.app.goo.gl/JT8G9TrKhtGVhqJM7
https://www.thingiverse.com/thing:2800913
It fits the RC 390 perfectly except needing just a little bit of fettling on the bottom half of the housing. Glued it in place using superglue. Pics in links below which should be self explanatory.
Pics and a small vid:
https://photos.app.goo.gl/LH8Kx2qVwDu2giZA8
Areas which I had to fettle on the throttle housing lower half:
https://photos.app.goo.gl/Un6gEo2poQ12C3GK9
WOT points:
https://photos.app.goo.gl/JT8G9TrKhtGVhqJM7
Last edited: