Recent content by itsmeblake

  1. I

    DIY Lights - Halos and turn signals

    I simply cut the stock sigs and wired these in place. There have been no hyperflashing issues.
  2. I

    DIY Lights - Halos and turn signals

    I took off the fairing and removed the front signals. While everything was apart, I cut all the wires to proper length and soldered them back together. I just realized that the stock white lick will not fit with this particular fender eliminator. I will likely get another led strip for this...
  3. I

    DIY Lights - Halos and turn signals

    I have everything more or less when I want so its time for some cutting and splicing. I drilled 2 small holes into the tail to feed the wires through. I could have used the area provided by the factory wires, but I wanted the cables to be invisible. I will update this post to show the...
  4. I

    DIY Lights - Halos and turn signals

    I removed the fender and licence plate as well as the rear LH/RH signals+wires. Then I mocked up what I wanted by sicking the LED strips to the under-tail. The stock 2 wire disconnect will be used AFTER everything has been mocked up. Here is the rear with the wires hanging everywhere! A...
  5. I

    DIY Lights - Halos and turn signals

    Hello all, l recently got an RC390 (first bike) and noticed that the USA bikes do not have the integrated turn signals that the Euro bikes get. After doing some digging, I found that nobody offers up a kit. The cost of buying euro mirrors from overseas exceeded the value. I ended up buying some...
See more
Top