Recent content by Vitboy

@ Sisco : Yes there a big difference. This airbox is a massive boost compare to the lid. You can also combine them. ( you'll need a bigger injector then)

i'm also lacking knowledge with the relation between the bigger injector and the ECU. I have the injector from Gray area but i have not yet installed it. My dealer finally refused to install it so i will do it by myself. As i'm new with these stuff, i'm wondering how the bike will start...

Hi all, I recently installed the WBC2 and it's working flawlesly. Trims are created evrywhere even in the 2% TPS column and i can feel the difference in closed and open loop area. Thanks Tom for your AFR base map. I ordered the larger injector as i also found a lid for the airbox :cool...

Hi, I just installed the Hardracing WBC2 ans i just wanted to say how easy it was. Even for complete noobs like me at mechanics. For a perfect installation i recommand to get a fuse tape ( the one earlier on this thread) and for the output of the WBC2 a connector like this ...

Understood, thanks !

Sorry for my noob question but what's the purpose of removing the canister ? Is it for the weight or is it better for the engine ? Could you tell me barely how much it weight ?

Thanks for the Update Ia02. I watched the video and i think it is as Tom describe it. Lcd 200 to enable the low voltage output then you fill the fuel cell with whatever you desire :-) Cya

Thank you, i wasn't aware of it. I will share my "story" on it !

Thanks for your answers, I initially thought that the AFR was set by Hardracing with the LCD 200 ("In the Closed loop section the WBC2 is feeding the spoof signal to the Stock ECU via the low voltage output (Green wire) to get the ECU to run the A/F that has been Pre-set by us") So i thought...

Hi all ! I'm planning to buy the WBC2 but i'm a bit confused : Here's what i don't understand , on the first page we can read : ( NOTE: The Low Voltage output.... is NOT part of the PowerCommander software Map you see on the computer screen. You cannot adjust the low voltage settings on...

Hi evryone, I'm a Vitpilen owner from France. I love this forum, this is where the best parts for this engine are ! So i hope, you will acept me. My bike is already equipt with a mivv pipe, gray area air intake mode and a PCV. I'm struggling with the PCV map, i'm here to find a solution ...

Vitpilen 401 Mivv Suono decat pipe - stock muffler DNA Air filter - Airbox with intake by Grey area KTM PC5