MNNTHBX RC Fender Eliminator

[diegs]

Are the LED bolts plug-and-play with the stock wiring or do you need to do your own splicing?

 

[MNNTHBX]

They splice in. Two wires. Scotchlocs would make it a 60 second job. Contact us if you have any questions. Greg

 

[Treachery]

Beat me to it. If you wanted to be overly fastidious, you could attach put one wire from each to a bullet connector and plug each of those into the OE connectors. The bolts are polarity independent.

 

[Fasteddy]

I found that the female pins from a computer power supply, like the black and yellow wires that go to adapters for video boards were the correct size. I salvaged (hacked connector apart) a couple of those, then butt spliced both LED's and one of the wires with female pin together, put heat shrink around pin and plugged into male side on main harness,heat shrink that, no intermittent scotch locks in the future...

 

[BrilliantB8]

Absolutely love this fender eliminator

 

[MNNTHBX]

Motorcyclist Magazine just installed our fender eliminator and some bits on their long term 390. Read here... Motorcyclist Magazine review : 2015 KYM RC390 Long-Term Test

 

[Treachery]

Showoffs.

J/K! Congrats on the pub!

 

[owspeed]

Thanks for a well build and great fitting part.

William
Santa Cruz, Ca

 

[daneo]

Just got this in the mail. Guessing I need to pull off the rear seat and get access to the bolts and wiring in there. Pretty self explanatory at that point?

 

[MNNTHBX]

These are 40% off for the remainder of the month! Discount shown at checkout.

MNNTHBX - Enter