threads

415 Front Sprockets are rolling off the machining center constantly now. Stock for the rear sprockets should be here later this week and will have an array of offerings for rear sprocket sizes. Sprocket fitment is perfect! These front sprockets are made from hardened Chromoly 4140, and have cold...

Think I stripped the threads in my radiator for the bleed screw. Has anybody done the same and tapped it for a bigger bolt successfully?

So I have a 16 RC now have about 450 mile on it, been hearing a vibration coming from under the instrument panel. I also had a large smear on the inside of the windscreen that I couldn't reach without taking it off. I used this rainy New England day to take the screen off and see if I could...

I searched, honest. I even tried to look it up in the CD service manual, but was unable to get that bahstid to work (see thread to this effect). Here's what was going on, and hopefully someone can post up the correct spec for the next person who searches: I have mounted the T-Rex Racing frame...

Greetings to you all , thank you the the moderators to allow me to post , but I hope you don't mind visitors from the " other side " Duke 390 forum . I'm thus a Duke 390 owner from Spain and some threads here have caught our attention . Very interesting threads and highly experienced technical...

I used to be able to use a Thread Tools tab to subscribe to threads etc. I dont see it anymore, and I see no way to subscribe to threads other than posting to them now. Can someone clear up those missing tabs that used to include Thread Tools? Thanks, Vaughn

While working on the initial service interval and shock swap, I had a part fall off the bike and hit the workstand... but I have NO idea where it came from, or what it's for. It LOOKS like a spacer, as there are no threads, but it's a hexagon shape. Try as I might, I can NOT figure out where it...