Hey all -
I’ve got a lot of parts going on to my 2018 RC390. I’ve got the PowerCommander and WB connected and everything seems to work fine (can’t yet start the engine - doing exhaust, coolant, brakes, forks, etc.), but now there is a rather loud chime when turning the key to the on position. Is this normal? Battery was disconnected for a bit - no waring otherwise on the dash. I only have 200 miles on the bike but I don’t remember the chime before this. Is it just indicating there is a reset happening?
The only warning that would fire now - is that my turn signals aren’t connected as the fairings are off. I should also say that I have the service manual - but it doesn’t say anything about this.
Any help is appreciated.
I’ve got a lot of parts going on to my 2018 RC390. I’ve got the PowerCommander and WB connected and everything seems to work fine (can’t yet start the engine - doing exhaust, coolant, brakes, forks, etc.), but now there is a rather loud chime when turning the key to the on position. Is this normal? Battery was disconnected for a bit - no waring otherwise on the dash. I only have 200 miles on the bike but I don’t remember the chime before this. Is it just indicating there is a reset happening?
The only warning that would fire now - is that my turn signals aren’t connected as the fairings are off. I should also say that I have the service manual - but it doesn’t say anything about this.
Any help is appreciated.
