Hey greetings from Norway, just bought a 2018 ktm rc 390. I am thinking about removing the stock stickers on the bike and was wondering if doing so will have any influence on the resell value of the bike.
Going to be picking up a 2017 rc 390, but had an odd question. I’ve always preferred the look of the 15-16 models, and was wondering if I could put on the lower fairing after removing side exhaust as well? Thanks
Decided to change the oil today (just got the bike few weeks ago 950 miles on it) When removing the lower fairings there's what I'm assuming is some kind of radiator shrouds attached to it. not the one on the radiator but below it attached to the fairings.
Upon removing the fairings it fell...
I have decided to only ride on the track and would like to remove my headlights. Short of completely removing the instrument cluster bracket or using my angle grinder; does anyone know the secret trick to removing the headlights or is it major front end surgery?
Hi, I haven't been able to find instructions to take off the RC390's windscreen. It looks like there are some kind of bolts I can't get to without removing both of the big white side panels, which I'd rather not do and hoping I'm missing something. Thank you for the help!
Disassembling the forks`
Hi all,
I thought I would give the andreani fork kit installation a try myself. I have drained fork oil, removed the outer tube from the inner. Now I'm looking at the inner tube cap. Is this cap screwed on? When removing the bottom mounts from the inner tube, are...
Dear KTM: Cotter pins? Seriously? I guess it cost too much to slot the hinge pin and source a circlip, huh? And boy, that right side- nice clearance on the rear master cylinder dust boot. I guess thats easier to access before you install the brake parts.
Stoopid cheap s***s.
Oh. To...
What are the steps to remove the levers? Normally I would just do it, but my last bike had a surprise when removing the levers. If you didn't follow a precise sequence pieces of the lever could break. After that I figure I should always ask first lol.
Question: My dealer says that KTM told him that the Akra exhaust can be installed with the stock belly pan. Can anyone confirm or dispute this? I would guess that it'd have to exit through the stock opening by removing the heat shield like others have done with the Fuel. Anybody know?