Hello folks. Hoping someone can give me some guidance or if they experienced this. I have a 2016 Cup bike and was installing a healtech quickshifter, motholders fairing stay and motion pro throttle. I removed the tank and disconnected the ecu to install the quickshifter to the fuel injector and did my throttle swap. I also had to disconnect the Speedo to route the harness through the opening on the race fairing stay. Reconnected everything and now upon start it will idle normally (2000-2500rpm) for about 30-45sec and then will jump to 6000rpm and won’t come back down.
Anyone have any experience with this or guidance on if Ive messed up the TPS by disconnecting and reconnecting the dash or ecu?
Thanks In advance.
Anyone have any experience with this or guidance on if Ive messed up the TPS by disconnecting and reconnecting the dash or ecu?
Thanks In advance.