Last edited:
Have you though about just running the brake light / turn signal combo that bolts to the plate? Like this one. They make it with built in signals as well.
I was trying for a similar to stock, O.E.M. look.Mine has integrated turn signals, just didn't want to have it on my plate
I was trying for a similar to stock, O.E.M. look.
And, Berrrrrr-rake light !
View attachment 1062
https://www.youtube.com/watch?v=NiK441nwpBE&feature=youtu.be
Well, to start with, this is the race seat available from KTM.now that is badass! do u mind sharing wat you used for the build? or possibly make a few and sell them to a few guys on here?
I'm not saying it's impossible but most likely improbable. The race seat is very flimsy and I doubt it would hold/support the stock tail light.Is there not anyway to put the stock lights into the ktm race seat?
Well, to start with, this is the race seat available from KTM.
The L.E.D.'s I bought on ebay (about $15 total) They are adhesive and just stick-on the back of the seat. I drilled a small hole for the wires to go through and snipped the wires at the end of the original tail light, to harvest the plug that goes to the harness.(simple soldering of the wires there)
The two 9 bulb strips I used in the middle for the running light, flanked by the two 18 bulb strips for the brake-light... Easy-peasy ! Red Bright 6" 18 LED Waterproof Flexible Light Strip w Adhesive IP65 SMD3528 | eBay and 2 Red 15cm 6" 9 LED Flexible Light Strip w Adhesive USA Seller | eBay
Not for me, since I rarely ever run a license plate, I like to leave it more towards a stock D.O.T. compliant look.You could possibly add some more strips on the sides and use them for your turn signals. Intergrated tail light ftw!! Lol
I'm not saying it's impossible but most likely improbable. The race seat is very flimsy and I doubt it would hold/support the stock tail light.
Plus, you would have to figure out a way to attach it securely. That's why I went in this direction…….