PCV O2 optimizer green connector mounting ideas?

[CDN Duke]

I've got my PCV installed but didn't really finalize the mounting of the O2 optimizer, and in particular the large green connector.

I grabbed this photo from another thread.

Just looking for ideas on how folks have mounted this on the bike please?

 

[cjwell]

Use the extra supplied adhesive velcro and stick it up under the tank cover about where your left knee would be, this applies to duke only.

 

[CDN Duke]

Use the extra supplied adhesive velcro and stick it up under the tank cover about where your left knee would be, this applies to duke only.

Thanks Chad,

This is what I ended up with, at least for now. I was concerned about folks other than me taking the tank cover off and not realizing something would be attached. Case in point, bike is back at dealer looking at possible frame replacement due to tail alignment concern and I think they took off most of the plastics. I'll look to redo, find permanent solution again later. May just need reminder to mechanic each time that there's wiring stuck underneath - not always easy to communicate directly with mechanic at this dealer currently however.