nut

I've run into this situation where my clutch doesn't disengage while my lever is pulled. I found a few mentions of the clutch nut holding the basket backing off - I ran out of time today and need to get a tool to hold the hub, but based on this picture would you say this is the culprit (still...

so I was torquing all the bolts on the bike after a longer ride. I got all of it torqued and then I saw the little brass nut on the side stand. Tried to torque it, and I broke it off. Sad panda. I saved it. I figured it was a stop for the stand to not go up to far. Tried it, and it worked...

Hello, While taking apart the bodywork this small golden nut thing fell out. Is it supposed to connect the coolant overflow tube (?) to the engine? Doesnt make sence to me, but it fits perfectly both ends for it. Yes, sorry for the dumb question, not a mechanic :) EDIT: the...

I am doing the last couple of jobs on my little bike for peace of mind... The first is , I am putting a M6 self locking nut ( with lock tight ) on the water pump so my question is ,, the shaft is it locked ?, like on a gear or would I need to hold the propeller while I undo the nut and put one...

We manufacture several GoPro accessories, such as our 390 stem nut, so it made since for us to become stocking GoPro dealers. All cameras ship free from MNNTHBX - Enter Proud to say we're now full line GoPro stocking dealers, and all GoPro products ship free from MNNTHBX - Enter

We've just released our new RAM mounts for the RC390. Hard anodized 6061. Available solo, with the wonderful X-Grip phone mount, GoPro mount, or all of it together. Perfect for GPS, filming, streaming music into helmets, etc..... FAR lighter than the OEM stem nut. $30.MNNTHBX - Enter

We've just released our new RAM mounts for the RC390. Hard anodized 6061. Available solo, with the wonderful X-Grip phone mount, GoPro mount, or all of it together. Perfect for GPS, filming, streaming music into helmets, etc..... FAR lighter than the OEM stem nut. $30.MNNTHBX - Enter

Another tid-bit from one of the RC390 Cup guys. Apparently, the nut holding the waterpump impeller on is not of the locking variety. With hard use they can back off the shaft. AMA Cup guys were told to replace the nut with a locking version. This is a relatively ease fix as the cover comes off...

Help!!! Top triple clamp 24mm nut torque? any one know the spec? Trying to install new "Driven" triple C Thanks in advance

There is a gear on the RHS end of the crank that drives the clutch (primary gear) as well as the cam chain. According to one of the RC Cup racers this gear needs to be tightened regularly if the bike is being raced. Apparently, it comes from the factory with insufficient torque on the nut. If it...