Chris RC390
Member
I just got a yoyodyne slipper clutch for my RC 390 and thinking about installing it myself. Look at a few YouTube videos and it doesn't look too hard. Is there anything I need to do before or during the installation? Such as where to install the judder spring. I don't have a clutch holding tool, should I buy one for this job? I do have a impact gun and also I seen people used a 2x4 in the rear wheel.
The inner clutch nut torque to 88.5 lbs ft. and the clutch spring bolt torque to 7.4 lbs ft.
Thanks in advance.
Chris
The inner clutch nut torque to 88.5 lbs ft. and the clutch spring bolt torque to 7.4 lbs ft.
Thanks in advance.
Chris