List of Mod's
Akro flash
bmc air filter (open lid)
mivv Ghibli exhaust
power commander 5 with a chad map for high comp gasket 42bhp before dyno
cometic high comp gasket (permatex used)
head and barrel machined
3 angle cut of valve seats and vac tested
porting to inlet and exhaust tract
port match of inlet rubber to head and exhaust port opened out and welds smoothed out in front pipe flange
throttle body smoothed out and top side radiused out by 2-3mm and threads and torx head of butterfly bolts reduced.
valve clearances set
exhaust front pipe wrapped in heat cloth tape.
motul 300v 15/50
had some high grade stainless steel washers made for the head bolts slightly oversize (diameter) as its clear that the cap head has pressed its self into the washer.
while apart i also added ti valve retainers and collets and single valve springs and the slightly shorter spark plug from chad, cam pulley bolts re loctited , water pump nut changed for a stainless steel nyloc and loctited .
Ape manual cam chain tensioner
factory pro shift detent lever
TSS slipper clutch
spal fan
1.6 bar rad cap
radiator moved forward by 8-10mm (need to trim inner fairings along from rad edge if you do this)
radiator air guide removed and mesh to protect from stones fitted.
also has the samco hoses with thermostat delete, cooling system filled with distilled water.
engine rubber cover is removed , fuel tank has been covered in heat reflective tape top and bottom
if it still suffers high temps at next track day ive a comapny who will make me a replica of the rad with a 10 or 15 deeper core .
it also has a strain gauge quick shifter fitted.
think i might get some second hand cams and send them off for grinding.