They borrowed my bike to build a power commander for the 2017.
I didn't ask them for a time line, but I'd guess there will be one available in the near future.
Mike
I purchased a fender eliminator from Tyga Performance on 02/06/17 and haven't received it yet. I know these guys have a huge following and I am far from worried about actually receiving it, however at $22 for "air shipping" i thought i would get it a bit sooner. Am i wrong for assuming that...
Rearsets installation happening tonight. What are you guys using for the swingarm bearing grease? I have some regular wheel bearing grease that works for tapered rollers. I'm going to guess these ones are just a smaller roller type. I'm positive that this grease is ok. But any input is...
Dear KTM: Cotter pins? Seriously? I guess it cost too much to slot the hinge pin and source a circlip, huh? And boy, that right side- nice clearance on the rear master cylinder dust boot. I guess thats easier to access before you install the brake parts.
Stoopid cheap s***s.
Oh. To...
Anyone done it? Tips! Tricks? Advice? Results?
ive done a bunch of KTM 950s that were pretty easy to remove. This I guess will require cutting.
Thanks.
.
For some reason the paint on our stock fuel cap is already chipping off, and getting some surface rust underneath.
Never sits outside in the rain. Guess, just poor quality India Gas Cap.
Nonetheless, we wanted to spruce up the bike, and installing the Driven HALO Fuel Cap was a super quick...
I bought a second K&N filter and when swapping them out I noticed quite a bit of oil inside the airbox? I've seen this before but not a puddle of oil, so my guess is that it was over coated with oil from the factory.
Interesting. I'll try to post some pictures later today. It is cracked right where the "tube" coming from the throttle body meets the main part of the airbox. Theres a huge ugly plastic "weld" going around the box which I guess is part of the molding process. That sucker is cracked all the way...
While I'm waiting for my new exhaust to be made, I thought I'd cut open my stock muffler and see if I could modify it for better flow and sound. First thing I noticed after wrestling it off? IT WEIGHS A TON!! I haven't actually weighed it, but I'd guess its 12-15llbs!
I then cut the outer shell...